Pay in installments of $6.24 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 1 - Jul 6
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
fabric pots for indoor plants AutoPot GeoPot Fabric Pot Systems, 1-100 PotsAutoPot GeoPot Fabric Pot Systems, 1 100 Pots Happy Hydro Fabric pots that water themselves, from one plant to a hundred The AutoPot GeoPot System pairs gravity fed, electricity free AutoPot irrigation with BPA free, lead free GeoPot G Lite fabric pots in 3 gallon or 5 gallon sizes. Each pot sits in its own XL tray with an AQUAvalve5 that fills to 1" of water, shuts off, and only reopens after the plant has consumed the entire supply. No pumps, no
Fabric pots that water themselves, from one plant to a hundred
The AutoPot GeoPot System pairs gravity-fed, electricity-free AutoPot irrigation with BPA-free, lead-free GeoPot G Lite fabric pots in 3-gallon or 5-gallon sizes. Each pot sits in its own XL tray with an AQUAvalve5 that fills to 1" of water, shuts off, and only reopens after the plant has consumed the entire supply. No pumps, no timers, no power outlet required. Start with a 1-pot system and expand to 100 pots on a single reservoir using tee connectors and expansion modules.
- Water daily or twice daily in fabric pots, which dry out faster than plastic
- Runoff collects in saucers and needs to be emptied manually
- Over or under-watering depends entirely on your judgment and schedule
- Leave for a weekend and plants can dry out completely
- Top-watering pushes salt buildup down into the root zone
- Adding more pots means more watering time
- AQUAvalve5 refills each tray automatically when the plant drinks it dry
- Bottom-fed system produces zero runoff, nothing to drain or dump
- Plants set their own wet/dry cycle, each pot independently
- Fill the reservoir and leave for days, the system keeps feeding
- Bottom feeding moves salts upward, away from roots
- Add pots with a tee connector, all share one reservoir
Air-pruned roots, not circling roots 3 gal or 5 gal
When root tips hit the porous fabric wall, air dries them and triggers secondary branching. The result is a dense, fibrous root mass with more surface area for nutrient uptake instead of roots spiraling at the edge of a plastic pot.
AQUAvalve5: plants decide when to drink
The dual-float valve fills each tray to 1" depth, then closes. It reopens only after the plant uses the entire supply, creating a true wet/dry cycle without any programming or electricity.
Wider 5mm inlet, less clogging
The AQUAvalve5 has a 5mm inlet, 66% larger than the previous generation. Wider 3/8" fittings and pipework mean faster flow through the system and far fewer blockages over a full grow cycle.
BPA-free, lead-free, double-stitched
GeoPot G Lite fabric is certified against off-gassing and leaching. Seams use bonded polyester thread, and the rigid base helps keep plants upright in the XL tray.
1 pot to 100 on the same reservoir Modular
Start with a 1-pot or 2-pot system. When you need more, add GeoPot expansion modules. Each module includes a tray, pot, valve, PotSock, pipe, and tee connector.
Reusable pots, washable between cycles
After harvest, let pots dry and brush off residue. For deeper cleaning, tub-wash in peroxide. Do not tumble dry. Most growers reuse the same GeoPots for years.
How to set up your GeoPot system
Place the reservoir above the trays
Position your reservoir at least 6" above the highest AQUAvalve5. Gravity is the only force moving water, so height matters. Install the tank filter and connect your 3/8" pipe run to the first tray.
Set up pots with PotSocks and media
Place a PotSock Round on the base of each GeoPot before filling. Use a 50/50 blend of growing media and aeration material (perlite, pumice, or clay pebbles). Transplant into the fabric pot and top-water by hand for the first 1 to 2 weeks to establish roots.
Open the tap and let the system take over
Once roots are established, open the inline tap. Each AQUAvalve5 fills its tray to 1", shuts off, and waits for the plant to drink before refilling. From this point, do not top-water.
Refill the reservoir, never let it run dry
Check the reservoir every few days and top off when it reaches one-third full. If it runs completely empty, air enters the lines and the AQUAvalve5 can lose its vacuum seal. Top off early, top off often.
- 4x 1Pot XL Grommeted Tray and Lid
- 4x 5-gallon GeoPot G Lite fabric pot
- 4x AQUAvalve5
- 4x PotSock Round
- 13 ft of 3/8" black pipe, tee/cross connectors, inline taps
- Reservoir and lid (size depends on variant selected)
- Golf filter or click-fit tank filter (FlexiTank orders)
- 2x2 tent: 1 pot (5 gal) or 2 pots (3 gal)
- 2x4 tent: 2 pots (5 gal) or 4 pots (3 gal)
- 3x3 tent: 2 pots (5 gal) or 4 pots (3 gal)
- 4x4 tent: 4 pots (5 gal) or 6 pots (3 gal)
- 5x5 tent: 6 pots (5 gal) or 9 pots (3 gal)
- Pot size: 3 gal or 5 gal GeoPot G Lite
- Reservoir: 12.4 gal hard tank, 13 or 25 gal FlexiTank, 60 gal FlexiTank PRO
- Optional add-ons: AirBase (replaces perlite drainage layer), AirDome Kit (pumps oxygen into root zone), extra PotSocks, Root Control Sheets, Expansion Modules to add more pots later
Questions? We're easy to reach.
Happy Hydro has been serving growers since 2006. Call or email us before you order, after you order, or any time something comes up. When you're happy, we're happy.
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy