gear joints Garagistic Standard Selector Joint - E30, E28, E24, E36Garagistic Standard Selector Joint E30, E28, E24, E36 25117503525 Overview One of the most noticeable, easy changes you can make to get rid of your BMW's shifter slop is replacing your aging OEM selector joint! Our Garagistic selector joints are produced in house from billet aluminum. We have taken the 30+ year old BMW selector joint design and brought it up to date by swapping out the plastic stationary bushing for a precision sealed bearing

Garagistic Standard Selector Joint - E30, E28, E24, E36 - 25117503525

Overview

One of the most noticeable, easy changes you can make to get rid of your BMW's shifter slop is replacing your aging OEM selector joint! Our Garagistic selector joints are produced in-house from billet aluminum. We have taken the 30+-year-old BMW selector joint design and brought it up to date by swapping out the plastic stationary bushing for a precision-sealed bearing assembly. By utilizing our new DSSR hardware that replaces the traditional pins and clips, this new design will allow you to snug the DSSR down on the selector joint without any binding and further eliminates any remaining slop in the shifter assembly. 

We recommend replacing your selector joint every time you refresh the shifter components to ensure a consistent, tight feel. Why not upgrade to the Garagistic Billet Selector Joint!

It's a really good idea to change your transmission fluid while you are down there. We recommend this fluid: https://amzn.to/41KYOnn . One of these is also helpful when you're doing it: https://amzn.to/3N3piN2

DO I NEED A SELECTOR JOINT, AND WHY?

The "standard" shift selector joint (BMW PN# 25117503525) will install on E30 Getrag transmissions running our short shifters. This is especially important on the E30 transmission that came from a car prior to 06/86 manufacture date. The earlier model shift selector joint has an offset cylinder and selector rod that is wider than the later model version. This earlier model does not fit a DSSR as the longer cylinder will not fit between the U cradle of the DSSR. As always with aging BMW parts, it is also advised to change the shift selector joint whenever you are performing maintenance on the shifter assembly.

The aging BMW transmissions are generally showing their age, and this selector joint ( BMW PN# 25117503525) has a plastic bushing that can wear out and cause slop. This selector joint is just one link in the system that can help tighten up your shifter feel and overall driving experience. Recommend changing these in the older BMW for maintenance. Mandatory to change the selector joint for use with a DSSR.

Fitment

WHAT CARS WILL THIS BMW SHIFT SELECTOR JOINT WORK IN?

• Direct Replacement: Direct replacement for BMW PN# 25117503525
• Fits: All E30 chassis produced after 06/86
• Does Not Fit: Pre 06/86 Early Model E30 OEM Selector Rods
  • Some early E30 and E36 318 models with selector joint part #25117501309 can upgrade to this selector (joint to be used with a Garagistic DSSR)
• Fits: E36 models up to production date 09/94*
• Fits: Late Model 2002s with a production date 03/1975 or later

Please Note: Factory OEM BMW selector rod pins may have slight variations in thickness and therefore some pins may have a tighter fit on our selector joints. This can be resolved with a quick cleaning (to remove grime and debris). In some cases, light sanding may be required. Our selector joints are a perfect fit for all of our DSSRs.

***IF YOU ARE UNSURE WHAT YOU NEED OR YOU HAVE OUR CHASSIS MOUNTED OR SUPREME OEM SHIFTER PLEASE CONTACT OUR SUPPORT TEAM BEFORE PLACING YOUR ORDER SO WE CAN ASSIST YOU IN PURCHASING THE CORRECT COMPONENTS FOR YOUR SHIFTER CONFIGURATION***